SUB 500
The Dynaudio SUB 500 reproduces deep bass with a natural yet powerful balance. Its incredible low frequency response is due in part to the new 30 cm (12") long-throw woofer developed for this model, which also features an extremely rigid die-cast aluminium frame, geometrically optimized for optimum air flow, a large diameter aluminium voice coil and a powerful magnet system.
The SUB 500 employs a 250W integrated amplifier module that also uses Dynaudio's advanced CEC (Cone Excursion Control) technology. The CEC circuitry allows the SUB to play deeper, louder and deliver higher dynamics with lower distortion than conventional subwoofer designs quoting even much higher power ratings.
The anti-resonant driver is coupled to the cabinet on a stiff metal baffle that is itself fused to the rigid MDF cabinet through a sheet of special damping material. This multi-layered sandwich construction further minimizes resonance and the detrimental effects of such.
The included remote control allows all subwoofer settings - phase, level, crossover frequency, and extended bass mode - to be both adjusted and stored right from the listening position.
Four fully programmable presets each can store all parameter settings into the subwoofer memory, allowing for independent settings for music, movies, late night or party modes, for example, while allowing each to be simply recalled at the touch of a button.
The memory functions are also able to be write-protected through a switch on the back panel so that they are not accidentally re-programmed.
| Frequenzy Response | 18 - 250 Hz |
| IEC Long Term Power Handling | 250 W |
| Lowpass | Flat/60/80/100 Hz |
| Phase adjustment | 0°/90°/180°/270° |
| Driver | 12" (30 cm) |
| Dimensions (W x H x D in mm) | 360 x 378 x 568 |
| Weight | 30,5 kg |
Manual (.pdf)
|
