Custom install speakers: frames and enclosures
We’ve designed our in-wall and in-ceiling frames and enclosures to be as easy as possible to install
Product design is all about problem-solving. That’s why, when we were creating the frames for our Dynaudio Custom in-wall and in-ceiling speakers, we made a long list of all the little woes and gripes installers commonly have… and then set about stamping them all out with clever solutions.
Room to manœuvre
Each frame can be adjusted within the cut-out cavity. That means if the hole isn’t completely plum and square, you can still make sure the speaker will be absolutely level. Best of all, you can fine-tune its position without calling for help – the frame is light enough to hold and move one-handed.
Clips (not screws)
When it’s in the right position, the enclosure uses innovative friction clamps to hold it in place. Again, these can be operated with one hand – and it takes just seconds to do. No screws, drills or additional helpers required. And best of all, it’s easy to loosen off the clamps and reposition the speaker housing if you need to.
The frames we use for our in-ceiling and in-wall speakers aren’t just off-the-shelf plastic. We spent months developing a composite that exhibits exactly the right combination of weight, stiffness and damping to stop unwanted vibrations, resonances affecting the speakers’ performance.
Now read this: How to install speakers in walls and ceilings