Your order

Close

Subtotals

Hub User manual

Xeo Hub
Connections and control elements

Front plate

Operational state

= connection to a speaker, Extender, or Link

= searching for a connection

= no connection

Rear plate – inputs

Aux In

Input for cable with stereo jack (3.5 mm stereo).

Connect devices here that have an output for the stereo jack.

Line In

Input for cable with RCA plug

Connect devices here that have an output for the RCA plug.

NOTE: If a device is connected in parallel at Aux in, only that device will be played back.

Optical In

Input for optical digital cable (Toslink).

Connect devices here that have an optical digital output.

Coax In

Input for electrical digital cable (coax).

Connect devices here that have an electrical digital output.

USB In

Input for USB cable

Connect your computer’s USB output here. The Hub will then work as a sound card.

Rear plate – other connections and control elements

Ethernet

Network connection

Intended for future use.

Id

Transmission channel

If you assign an ID, you can select the desired Hub from several Hubs using the remote control.

In addition, each ID has its own transmission channel: A = 2.4 GHz, B = 5.2 GHz, C = 5.8 GHz. If the transmission quality is poor or there is a disruption caused by other radio systems, changing to a different channel may produce an improvement.

Power

Connection for power supply unit

Connect the delivered Xeo power supply unit here.

Do not use a different power supply unit!

Connection

  • Connect the Hub to the mains voltage using the POWER connection and the Xeo power supply unit. Do not use a different power supply unit!
  • Connect your signal source to the appropriate input on the Hub.

For a selection of signal sources and options for connecting to the Hub or Connect, see “Connection options for Hub/Connect”.