Use the supplied power cable to connect the loudspeakers to the mains voltage and switch it on using the power switch (POWER) on the rear (position I).
Switching on/standby mode
To switch the loudspeaker on from standby mode:
Point the remote control at the loudspeaker and press the ON button. The loudspeaker will automatically search for an audio signal or an active hub. If found, the signal will be output. If there is no input signal, the loudspeaker will go into standby mode after a certain period.
To switch it back on, press ON or start music playback.
To switch a loudspeaker out of operation to standby mode:
Point the remote control at the loudspeaker and press the OFF button. The loudspeaker will go into standby mode. To completely switch off the loudspeaker, turn the POWER switch on the rear to „O“. However, the loudspeaker can then no longer be switched on via the remote control.