Your order

Close

Subtotals

Xeo 20 User manual

Fixing the Volume

You can set the speaker to a higher volume using the function to fix the volume. This setting also remains in effect in standby mode. If a signal source is connected to the Xeo 10/20/30 with its own volume control, you have the option to change the output volume across a broad range with the signal source.

To fix the volume:

  • Point the remote control at a speaker and press for at least 2 seconds. To undo fixing, press one of the two volume buttons.

Standby

To switch speakers to sleep mode:

  • Point the remote control at a speaker and press or press on top of one of the speakers.
  • The speakers will enter sleep mode.
  • The speakers also enter sleep mode if there is no audio signal for 20 minutes.
  • In this mode, the wireless network is active and all connected units remain synchronized.
  • Sleep mode power consumption is <2 W.

To switch speakers to low-power standby mode:

  • Press and hold on the remote control for at least 5 seconds.
  • The speakers go to low-power standby mode.
  • In this mode, the wireless network is disabled and the speakers are not connected to each other.
  • Low-power standby mode power consumption is <0.5 W.

To turn off auto standby:

  • Press and hold on the remote control for at least 5 seconds.